Electrical on/off

805313619 - SOLENOID OPERATED CARTRIDGE SV08-34-04-00-00-B-00 - DANFOSS
Description: SV08-34-04-00-00-B-00
Function: 4 WAY-3 POS ON-OFF SPOOL VALVE
Solenoid Valve, 4-way, 3-position, Spool Type 230 bar [3300 psi] • 8 l/min [2 US gpm]
This is a 4-way, 3-position, spool type, direct acting solenoid valve. In the center condition, ports 2 and 4 are closed while port 3 is connected to port 1. By energizing one coil, port 3 opens to 2 and port 4 to 1. When energizing the other coil, port 3 opens to 4 and port 2 to 1. This valve provides a directional control function with a neutral de energized state allowing the inlet flow to pass to tank or to another function while the work ports are blocked. It can be used in any hydraulic application where an actuator needs to be controlled in both directions.
805314219 - SOLENOID OPERATED CARTRIDGE SV10-24-01-00-00-B-00 - DANFOSS
Solenoid Valve, 4-way, 2-position, Spool Type
230 bar [3300 psi] • 35 l/min [9 US gpm]
This is a 4-way, 2-position, spool type, direct acting solenoid valve. In the de-energized, condition port 3 is open to 2 and port 4 to 1. When energized port 3 is open to 4 and port 2 to 1. These valves are used to control the movement of cylinders or motors able to reverse the motion. Always check the  operating envelope to make sure the valve will work under the required application conditions. Port 1 is not intended for use as an inlet (Tank only).
805347319 - SOLENOID OPERATED CARTRIDGE SV10-24-12-00-00-B-00 - DANFOSS
Description: SV10-24-12-00-00-B-00
Function: 4 WAY-2 POS ON-OFF SPOOL VALVE
Solenoid Valve, 4-way, 2-position, Spool Type 230 bar [3300 psi] • 25 l/min [6.6 US gpm]
This is a 4-way, 2-position, spool type, direct acting solenoid valve. In the de-energized condition, port 3 is open to 1 while ports 2 and 4 are blocked. When energized, port 1 is open to 4 and port 2 open to 3. This valve allows the inlet oil to pass through the valve to tank or a separate system while holding the actuator in position. Always check the operating envelope to make sure the valve will work under the required application conditions. Port 1 is not intended as inlet (Tank only).