Hydraulic Valves

Description: CEBN-060-NAFN-32-S08-N350
Function: 2 WAY-2 POS.ON-OFF POPPET VALVE NORMALLY OPEN DOUBLE LOCK

Using Danfoss Genuine Parts you can guarantee maximum reliability of your equipment, maximizing productivity and performance. By using non-original spare parts you will save on cost but a negative impact on the performance and strength of your equipment.
Function: M16 Deutsch

CV10-NP
Check Valve, Standard Direction
350 bar [5000 psi] • 80 l/min [21 US gpm]
DESCRIPTION AND OPERATION
This is a check valve where free flow takes place from port 1 to 2 and is blocked from port 2 to 1

PVE SERIES 7 
The PVE S7 models are 100% backwards compatible with PVE Series 4.
Code Number: 11166824Type: PVEHConnector: 1x4 DINSupply Voltage: 11V-32V
* Image for illustration purposes only

Using Danfoss Genuine Parts you can guarantee maximum reliability of your equipment, maximizing productivity and performance. By using non-original spare parts you will save on cost but a negative impact on the performance and strength of your equipment.

SV08-34-05
Solenoid Valve, 4-way, 3-position, Spool Type
230 bar [3300 psi] • 12 l/min [3.2 US gpm]

CV10-NP
Check Valve, Standard Direction
350 bar [5000 psi] • 80 l/min [21 US gpm]
DESCRIPTION AND OPERATION
This is a check valve where free flow takes place from port 1 to 2 and is blocked from port 2 to 1

Solenoid Valve, 4-way, 2-position, Spool Type
230 bar [3300 psi] • 35 l/min [9 US gpm]
This is a 4-way, 2-position, spool type, direct acting solenoid valve. In the de-energized, condition port 3 is open to 2 and port 4 to 1. When energized port 3 is open to 4 and port 2 to 1. These valves are used to control the movement of cylinders or motors able to reverse the motion. Always check the  operating envelope to make sure the valve will work under the required application conditions. Port 1 is not intended for use as an inlet (Tank only).

Flow Divider/Combiner, Fixed Ratio, Flow Synchronizing Option 
210 bar [3000 psi] • 45 l/min [12 US gpm]
This is a fixed ratio flow divider/combiner valve. In dividing mode, flow enters port 3 and passes across two fixed orifices in linked spools. If the pressure drop through one orifice is higher than the other, then the spools will move together to restrict the flow in the lower pressure outlet port. This maintains  equal pressure drops across the spools, thus maintaining the flow division in the outlet ports. In combining mode, flow will enter ports 2 and 4 pass  through the orifices, which causes the spools to move to restrict the higher-pressure inlet and maintain equal pressure drops and equal flow into the  valve.

Why use original Danfoss spare parts?
Maximum Efficiency of the components and the system
Preventing failure or breakdown
Safety
Environmentally friendly
Increased system lifespan…by as much as 50%!
* Image for illustration purposes only

Using Danfoss Genuine Parts you can guarantee maximum reliability of your equipment, maximizing productivity and performance. By using non-original spare parts you will save on cost but a negative impact on the performance and strength of your equipment.

Description / Function:SAE-08-2N 3/8"G Steel